Saab 9-5

since 1997 of release

Repair and car operation


Saab 9-5
+ Saab 9-5 Cars
+ Governing bodies and operation receptions
+ Settings and routine maintenance of the car
+ Engine
- Systems of cooling of the engine, heating, ventilation and air conditioning
   + System of cooling of the engine
   - Systems of heating, ventilation and air conditioning
      General information
      Removal and control unit installation by ventilation system with a heater and To/in, removal and installation of the broad valve
      Replacement of the valve of an otsechka of cooling liquid and it Ý/m the valve
      Removal and installation of the fan of a heater
      Removal and heat exchanger installation
      Removal, repair and To/in compressor installation
      Removal and installation of the sensor of temperature in salon
      Removal and installation of the step-by-step engine of a zaslonka of mixing of air and э / motor of a zaslonka of a mode of air circulation
+ the Power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

chat ia

Removal and installation of the fan of a heater

 PERFORMANCE ORDER

  1. Switch off a mode of circulation and switch off ignition.
  2. Remove levers of screen wipers and rubber consolidations from their spindles.
  3. Disconnect from the center of a partition of an impellent compartment its consolidation.

Lateral clamps do not remove.

  1. Remove a windscreen fairing. For a fairing detachment from glass pull a fairing forward.
  2. Liberate the water filter from clamps and remove it.
  3. Turn out 4 bolts of fastening of the mechanism of screen wipers and remove it, having separated the socket.
  1. Give 2 nuts at forward edge of a frame round the heater fan, liberate it from two clamps and remove it (9 on an illustration).
  1. Turn out 3 bolts and remove an arm of levers of screen wipers (10 on an illustration), located over the heater fan.
  1. Disconnect an electroconducting plait from a fan cover (11 on an illustration), turn out 4 bolts and uncover (12).
  1. Raise the heater fan, separate its socket and cut cable couplers of its electroconducting (13 on an illustration).
  2. Extend the fan sideways.
  3. Installation is made upside-down.