Saab 9-5 + Saab 9-5 Cars + Governing bodies and operation receptions + Settings and routine maintenance of the car + Engine + Systems of cooling of the engine, heating, ventilation and air conditioning + the Power supply system and production of the fulfilled gases + Systems of electric equipment of the engine + Manual box of gear shifting + Automatic transmission + Coupling and power shafts + Brake system + Suspension bracket and steering - Body - External equipment and body elements Removal and installation of bumpers Removal and installation decorative radiator reshyotok Removal and installation of spoilers Removal and installation of a covering and decorative panel of a trunk lid Removal and installation of loker of wheel arches Removal and installation of forward wings and windscreen fairing Removal and installation of beams of the top luggage carrier of the Versatile person models Removal and installation of assembly of the top hatch and its components Removal and installation of a cowl and its lock Removal, installation, dismantling and assembly of a forward door and its components Removal, installation, dismantling and assembly of a back door and its components Removal, dismantling, assembly and installation of a door of a back and its components Removal and installation of a trunk lid and its components The fixed glasses + salon Equipment + Onboard electric equipment
|
Removal and installation of assembly of the top hatch and its components
Assembly of the top hatch
|
- Remove a ceiling covering.
- Remove the console of the main salonny lamp, separate the electroconducting socket э / the motor of a drive of a cover of the hatch and leave the console to hang on an electroconducting plait.
|
- Disconnect from unions on assembly of the hatch of 4 drainage tubes (3).
|
- Give assembly fixture, having left one screw on a first line and on the screw in each back corner of assembly (4,5). Then together with the assistant, turn out these remained screws and remove assembly of the top hatch.
- Installation is made upside-down. In summary check serviceability of functioning of the hatch.
|
|
Cover of the hatch and э / motor of its drive
|
|
- Open the hatch and turn out screws of a slip on a forward part of its cover (2).
|
- Close the hatch and lift its back part.
- Pull for back edge of a cover back to unhook its slip from clamps (4).
|
- Remove from clamps lateral slips (5), lift a back part of a cover of the hatch, turn out two bolts (7) and uncover.
|
|
At removal э / the motor to turn out screws and it is not necessary to uncover, it is enough to remove slips. |
|
- Close the hatch and make sure that sliding support are located between labels on the directing.
|
|
At installation of the new motor the hatch should be closed, since the motor is delivered in this situation. |
- Remove sun-protection peaks and separate the socket of electroconducting of illumination of a mirror.
- Remove a rasseivatel of the salonny lamp, turn out screws and remove the ceiling console.
- Remove an internal rear-view mirror.
|
- Turn out fastening bolts э / the motor (10), then accurately unbend a covering of a ceiling and remove э / the motor, having separated its electroconducting (11).
|
- Installation is made upside-down. Before a fixture tightening э / the motor move it to be convinced of gearing of gear wheels of a drive. A cover of the hatch level with a roof. The arrangement of a first line a little below back edge is allowed.
|
|
|
|